Boehmer Heating & Cooling Blog: Posts Tagged ‘Bridgeville’

How Do I Reduce Dust in My Home?

Monday, May 23rd, 2011

Dust is everywhere. There is no way to stop it from occurring, so instead we turn to cleaning and filtration to keep the amount of dust circulating through the air to a minimum. Luckily, there are quite a few things you can do, even without installing new equipment, to reduce your dust levels.

Duct Cleaning

First on the list is regular duct cleaning. You dust your furniture and your floors, so why not clean out your ductwork? Properly cleaned ductwork is very important because of just how much stuff can build up in there over time. Imagine regular air flow in an enclosed space that never gets cleaned. How much dust and debris do you think could build up over the course of a year? Hint: it’s enough to keep a steady flow of dust in your indoor air.

Professional duct cleaning is important and should be done once every year or two depending on how often you use your home comfort system. However, you should also clean in and around the vents and ducts in your home where you can reach. This can be done weekly and will help immensely to reduce dust.

Filtration

Most air filters equipped with high quality HEPA filters work extremely well to remove dust from the air. Because HEPA filters can capture particles as small as 0.3 microns, they won’t just remove dust, but pollen, pet dander and even mold. Mold especially is a problem that occurs in far greater frequency in homes without filtration.

Simple air filtration is an affordable solution to a lot of different contaminants, so it’s a good fit for any home. However, there are more powerful systems as well that will reduce both dust and pathogens like bacteria – these purifiers use ionization to draw particles from the air electronically.

Humidity

Humidity imbalance can cause dust problems as well. Low humidity leads to more dead skin and dust in the house, while high humidity causes the development of dust mites. Properly regulating your humidity to slightly less than 50% will create a perfect environment in which less dust is created and circulated in your home.

The best way to reduce dust is to take a three pronged approach to indoor air quality. Cleanliness is always first on the list, but after that don’t neglect the value of filtration and proper humidity control. When used properly, these three things will ensure dust never bothers you again.

Continue Reading

Changes in Light Bulb Laws and Technology

Wednesday, April 20th, 2011

In 2007, Congress passed the Energy Independence and Security Act, which promoted many forms of renewable energy and energy conservation. Its provisions include changes to the minimum standards for light bulb efficiency. Although the new standards haven’t officially gone into effect yet, you many already have seen changes in the kinds of light bulbs on sale in your local hardware store.

According to the law, starting in 2012, most standard general-purpose bulbs must be 30% more energy efficient than current incandescent bulbs. The new requirements will be phased in gradually, but the net result will be that by 2014, most of today’s incandescent bulbs will no longer be available for sale, and will be replaced by compact florescent light bulbs, or CFLs.

Of course, higher-efficiency bulbs are good for the environment. Moving to more efficient lighting is one of the easiest, lowest-cost ways for the U.S. to reduce electricity use and carbon emissions. But the changes will also benefit consumers – some estimates suggest that the average household’s utility bill will be reduced by as much as 12%. Even though CFLs cost more to buy ($3 compared to 50 cents for an incandescent), they use about 75% less energy and last five years instead of a few months. Depending on the cost of electricity, a homeowner that invests $90 to change 30 bulbs to CFLs will save between $440 and $1500 over the five-year life of the bulbs.

CFLs do have their detractors. Many claim that they don’t last anywhere near as long as the five years claimed by manufacturers – and this can in fact be the case you turn the bulbs on and off frequently. Energy Star recommends that all CFLs be left on for at least 15 minutes at a time. (Also, if you are using the bulbs in a dimmer, make sure that you buy bulbs specifically marked “dimmable”.) If you buy Energy Star bulbs, they come with a two-year warranty, so save your receipts and contact the bulb’s manufacturer if it burns out prematurely.

Others dislike the white – sometimes called “harsh” – light of CFLs. This effect can be mitigated by buying cooler-burning CFLs. Bulbs with Kelvin temperatures in the range of 2,700 to 3,000 emit a warmer light than higher-temperature bulbs with Kelvin temperatures of 5,000 or higher, which tend to have a white or bluish light.

Still other critics point out that CFLs contain mercury. While this is true, incandescent bulbs are not mercury-free in practice either. The increased power used for incandescent likely comes from coal-powered plants that produce mercury and many other types of pollution.

If you do break a CFL in your home, consult the EPA’s website for instructions on how to clean it up safely. http://www.epa.gov/cfl/cflcleanup.html

Of course, manufacturers are preparing for 2012 by developing new kinds of light bulbs that meet the more stringent standards, including high-efficiency incandescent and LED bulbs, so look for these options to arrive in stores over the next year or so.

The good news? A much less-beloved light bulb has already been phased out. The T-12 fluorescent tube – those humming, flickering office lights that give everyone’s skin a miserable greenish cast – has been replaced by T-8 fluorescent tubes, which are quieter, more efficient, don’t flicker, and make colors look much more natural.

Continue Reading